aliennsa.blogg.se - Eurosec pr5208 rev10 user manual

Text is entered in a similar way that you would enter text on a mobile telephone.

the display will show for example:- Code #. 9 Press a single digit corresponding to the user number (1 to 9) that you wish to program. Program Codes ? Press Yes the display will show:- Select 1.

Press No the display will show:- Do You Want to.

User Numbers 8 to 9 Set Only Level Allows Set Only User Number 1 is factory default 5678. User Numbers 4 to 7 User Level Allows Set, Part Set and Unset. User Numbers 1 to 3 Master Level Allows Set, Part Set, Unset and User Programming Mode.

: Programming User Codes Programming User Codes Up to nine user codes may be programmed on predetermined levels these are.

Turning Chime On/Off Your installation company may have programmed a group of zones or a single zone as Chime. To escape back to Unset press 0 three times. To test the bells (external sounders) and strobe press 9.

: Turning Chime On/off Violate each zone on the system (as you do so the display will show the violated zone) to verify its integrity.Set User 1 ? Press Full for Full Set Press Part for Part 1 Set Press 2 for Part 2 Set Press 3 for Part 3 Set The system will now start the relevant Set with the zones you deleted removed from the Set. : System Test Press 0 twice the display will show for example:- Do You Want to.It is only applicable to the one Set state and will need to be repeated for subsequent Sets. Delete Zone Option This option allows individual zones to be deleted (omitted) when the system is being set. To use these options please continue below. : Programmable User Options Programmable User Options Several user programmable options are available via user codes 1, 2 or 3.The display will show the zone that caused the alarm. Display After an Alarm After an alarm has occurred the system should be unset as above. Proceed to the keypad and enter a valid User Code. : Unsetting The System Unsetting the System Enter the premises via an authorised Entry Point.Part Set zones will be omitted from the system when that particular Part Set is used. Please refer to the customer details at the rear of this manual for information about Part Set zones. : Part Setting The System (using Part 1) Part Setting the System (using Part 1) Up to three Part Sets may be available for your system.Throughout this manual refer- ence will be made to the User Code, the factory set default is 5678. Several user programmable options are available that will be covered later in this manual. Your installation company will have programmed your system to protect your premises to the highest possible standards. : Introduction Introduction Welcome to the eurosec control panel.1 Part Setting the System (using Part 1). : Table Of Contents Contents Introduction.Related Manuals for EUROSEC CP8L Summary of Contents for EUROSEC CP8L